==========================================================================
The checksum's (found through sum -r) of the files that you have received
(other than this README) are as follows:

30317      2 patchSG0000203
51018   3410 patchSG0000203.explorer_sw
14121      2 patchSG0000203.idb
==========================================================================



				  - 1 -



       1.  Patch_SG0000203_Release_Note

       This release note describes patch SG0000203 to IRIS Explorer
       version 2.2.2 for IRIX 5.3.

       1.1  Supported_Hardware_Platforms

       This patch contains bug fixes for all platforms.

       1.2  Supported_Software_Platforms

       This patch contains bug fixes for IRIS Explorer version
       2.2.2 for IRIX 5.3. The software	cannot be installed on
       other configurations. In	particular, it should not be
       installed on IRIX 6.0.1.

       1.3  Bugs_Fixed_by_Patch_SG0000203

       This patch contains fixes for the following bugs	in IRIX
       5.3.  Bug numbers from Silicon Graphics bug tracking system
       are included for	reference.

	  o Bug	#250826	- Module Builder and Data Scribe use wrong
	    fonts. The Module Builder and Data Scribe of Explorer
	    version 2.2.2 use the wrong	fonts. This happens because
	    the	XUSERFILESEARCHPATH environment	variable changed in
	    IRIX 5.3. This patch allows	both applications to use
	    the	correct	fonts.

       1.4  Subsystems_Included_in_Patch_SG0000203

       This patch release includes these subsystems:

	  o patchSG0000203.explorer_sw.eoe

	  o patchSG0000203.explorer_sw.dev


       1.5  Installation_Instructions

       Because you want	to install patches for only the	problems
       you have	encountered, patch software is not installed by
       default.	After reading the descriptions of the bugs fixed in
       this patch, determine the patches that meet your	specific
       needs.

       Patch software is installed like	any other Silicon Graphics
       software	product.  It must be installed from the	miniroot.
       Follow the instructions in your IRIS Software Installation
       Guide to	bring up the miniroot form of the software
       installation tools.











				  - 2 -



       Follow these steps to select a patch for	installation:

	 1.  At	the Inst>prompt, type

	     install patchSG0000203

	     where 0000203 is the patch	number.

	 2.  Select the	desired	patches	for installation.

	 3.  Initiate the installation sequence. Type

	     Inst> go

	 4.  You may find that two patches have	been marked as
	     incompatible.  If this occurs, you	must deselect one
	     of	the patches.

	     Inst> keep	patchSG0000203

	     where 0000203 is the patch	number.

	 5.  After completing the installation process,	exit the
	     inst program by typing

	     Inst> quit


       To remove a patch, use the versions remove command as you
       would for any other software subsystem.	The removal process
       reinstates the original version of software unless you have
       specifically removed the	patch history from your	system.

       versions	remove patchSG0000203

       where 0000203 is	the patch number.

       To keep a patch but increase your disk space, use the
       versions	removehist command to remove the patch history.

       versions	removehist patchSG0000203

       where 0000203 is	the patch number.
















