-------------------------------------------------------------------------------
Interphase Corp.  - CFDDI Driver - RMF - Document No. UGRMF86-000, Rev. B


  RRRR   EEEEE    A    DDDD    M   M  EEEEE   FFFFF  I  RRRR    SSS   TTTTT
  R   R  E       A A   D   D   MM MM  E       F      I  R   R  S   S    T
  RRRR   EEE    A   A  D   D   M M M  EEE     FFF    I  RRRR    S       T
  R R    E      AAAAA  D   D   M   M  E       F      I  R R       S     T
  R  R   E      A   A  D   D   M   M  E       F      I  R  R   S   S    T
  R   R  EEEEE  A   A  DDDD    M   M  EEEEE   F      I  R   R   SSS     T




                       HP-UX 10.x CFDDI DRIVER R1.3


   
   This document contains Application Notes, Installation Notes, 
   Corrections, and Deficiencies of the Interphase HP-UX 10.x CFDDI 
   Driver for HP 9000 Series.
   
   
   Part Numbers:  SM00022-A03 DDS tape distribution
   		  SX00312-A03 media independent image
   
   
   Application Notes:
   ------------------
   
   This release of the CFDDI driver is intended for use with
   HP-UX 10.00, 10.01, 10.10, 10.20.  It is also safe to use on 
   multi-processor systems.
   
   The following HP 9000 Series hardware models are supported by 
   this release:
   
   	700 Series Workstations w/EISA
	C Class Workstations w/EISA
	D Class Server w/EISA
	J Class Workstation w/EISA 
   
   Installation Notes:
   -------------------
   
   This driver may be installed over a previous release. It is not
   necessary to remove the old version.

   To install the CFDDI driver, run 'swinstall'.  When viewing the 
   products on the tape, the Interphase product will appear as the name 
   "CFDDI" with the information field reading "Interphase CFDDI EISA Driver".

   When the install script is completed, it will build a new kernel and reboot
   the system.  After rebooting, it will be necessary to configure the card for
   operation via the SAM program.  Once this is done, the board will be
   automatically configured each time the system is rebooted.

   If you wish to remove the software from the system, it is necessary
   to remove the driver from the system using SAM before running 'swremove' to
   uninstall the software.

   Corrections/upgrades:
   ---------------------
 
   The corrections listed below describe changes made to the driver since
   previous released version: 

	Symptom : NFS failures or system panic using HP-UX 10.20.
 
	Cause   : The 4811 driver object that was detected and installed
            on 10.20 systems for the previous release was not
            compiled on HP-UX 10.20.
 
	Solution: The correct object files are now compiled using
            the appropriate compiler for each target operating
            system revision.
 
 

 
   Deficiencies:
   --------------
   
   The following are known problems with this release:

   None known.